Number System
The number system is the foundation on which every other chapter of General Mathematics rests, and in the ADRE Grade III paper it is tested through short, direct questions rather than long calculations. A candidate who is comfortable with the families of numbers, the place value of a digit, the divisibility rules and the idea of the unit digit saves time on almost every later chapter, because percentage, ratio, average and mensuration all begin with an honest calculation that a careless error in the number system turns wrong.
Numbers are grouped into natural numbers, whole numbers, integers, rational numbers and irrational numbers. Natural numbers begin at one and are used for counting. Whole numbers begin at zero and add zero to the natural numbers. Integers add the negative counting numbers, so that subtraction is always possible. A rational number can be written as a fraction of two integers with a non-zero denominator, and every integer, terminating decimal and repeating decimal is rational. An irrational number such as the square root of two, the square root of three or pi cannot be written as such a fraction, and its decimal expansion never ends and never repeats.
The place value of a digit depends on its position, while the face value is the digit itself. In the number 3,74,251 the face value of seven is seven, but its place value is seventy thousand, because it sits in the thousands place of the Indian system of grouping. The Indian system groups digits as ones, tens, hundreds, thousands, ten thousands, lakhs and crores, whereas the international system uses ones, tens, hundreds, thousands, ten thousands, hundred thousands and millions. Writing a number in the expanded form makes the place value of every digit visible at once and is a reliable way to avoid errors in questions about the largest or smallest number formed from a set of digits.
Divisibility rules turn a slow long division into a quick check. A number is divisible by two if its last digit is even, by five if its last digit is zero or five, and by ten if its last digit is zero. It is divisible by four if the number formed by its last two digits is divisible by four, and by eight if the number formed by its last three digits is divisible by eight. It is divisible by three if the sum of its digits is divisible by three, and by nine if the sum of its digits is divisible by nine. It is divisible by eleven if the difference between the sum of the digits in the odd places and the sum of the digits in the even places is zero or a multiple of eleven. These rules are used again and again in questions that ask for the smallest number to be added or subtracted to make a given number divisible.
The unit digit of a large power depends only on the unit digit of the base and on the pattern that the powers of that digit repeat. The powers of two repeat the last digits two, four, eight and six; the powers of three repeat three, nine, seven and one; the powers of seven repeat seven, nine, three and one; and the powers of four and nine repeat only two digits. Dividing the exponent by the length of the repeating cycle and looking at the remainder gives the unit digit quickly, without calculating the full power.
Prime numbers and composite numbers matter in many later chapters. A prime number has exactly two factors, one and itself. Two is the smallest prime and the only even prime; one is neither prime nor composite because it has only one factor. A composite number has more than two factors. The number of factors of a number can be found by writing it as a product of powers of primes and multiplying one more than each exponent. For example, forty-eight is two to the power four times three, so it has five times two, that is ten, factors. Two numbers are co-prime if their highest common factor is one, and this idea links the number system to the chapter on HCF and LCM.
Rounding and approximation are tested because the Grade III paper rewards a candidate who can judge an answer quickly. Rounding a decimal to two places looks at the third decimal digit: if it is five or more the second digit is raised by one, otherwise it is left alone. Estimation is not the same as guessing; it means replacing awkward numbers with convenient ones so that the final answer can be checked against the options.
Approximation also helps in eliminating wrong options. If a question asks for the value of a long expression and the options are far apart, a quick estimate of the leading digits usually leaves only one choice. Candidates should practise both the exact method and the estimate, because some questions are built to be solved quickly and some are built to test accuracy.
The most common mistakes in this chapter are worth naming. Candidates forget that one is neither prime nor composite, that zero is a whole number but not a natural number, and that the smallest two-digit number is ten while the smallest three-digit number is one hundred. They also confuse the smallest even number, which is two, with the smallest even natural number, and they forget that a number is divisible by six only when it is divisible by both two and three. Keeping a short list of these facts and revising it before the examination removes a whole class of easy errors.
A good routine for revision is to spend ten minutes a day on the families of numbers, the divisibility rules and the unit-digit cycles, because these three ideas cover the majority of the questions that this chapter throws up. Write the divisibility rules on a single card, write the square numbers up to thirty beside them, and revise the card for a week. On the day of the examination the number system will then be a place to bank marks quickly rather than a place to lose them to carelessness.
The number system is the foundation of arithmetic, and the questions test the classification of numbers, the divisibility rules and the properties of the natural numbers. The candidate should know the meaning of the natural numbers, the whole numbers, the integers, the rational numbers, the irrational numbers, the real numbers, the prime numbers, the composite numbers and the co-prime numbers. Each term has a precise meaning, and the paper often asks which of a given set belongs to a particular class.
A natural number is a counting number, a whole number includes zero, and an integer includes the negative numbers. A rational number can be written as a fraction of two integers, and an irrational number cannot; the square root of two and the value of pi are irrational. A prime number has exactly two factors, one and itself, and a composite number has more than two factors. One is neither prime nor composite, and two is the only even prime number.
The divisibility rules are frequently asked, and they save a lot of time. A number is divisible by two if its last digit is even, by three if the sum of its digits is divisible by three, by four if the number formed by the last two digits is divisible by four, by five if its last digit is zero or five, by eight if the number formed by the last three digits is divisible by eight, by nine if the sum of its digits is divisible by nine, and by eleven if the difference of the sums of the digits in the odd and the even places is divisible by eleven.
The highest common factor and the lowest common multiple are the two most useful tools of the topic. The highest common factor of two numbers is the greatest number that divides both, and the lowest common multiple is the smallest number that is divisible by both. The product of the two numbers equals the product of their highest common factor and their lowest common multiple. This relation is used to find one of the four quantities when the other three are known.
The questions on the remainder and the unit digit are also common. The unit digit of a product depends only on the unit digits of the factors, and the unit digit of a power follows a cycle. The remainder when a number is divided by another can be found by using the property that the remainder of a sum is the sum of the remainders, and the remainder of a product is the product of the remainders, each taken modulo the divisor. These short rules answer the questions on the large powers and the large products.
The topic also includes the fractions, the decimals and the surds. A decimal can be converted into a fraction by writing it with the denominator as a power of ten, and a recurring decimal has a special method. A surd is an irrational root, and two surds can be compared by squaring them or by rationalising the denominator. A candidate who is comfortable with these conversions can solve the questions on the number system, the simplification and the surds.
- Natural numbers begin at one, whole numbers begin at zero, and integers add the negative counting numbers.
- The smallest prime number is two, and it is the only even prime.
- One is neither prime nor composite because it has only one factor.
- Divisibility by three and by nine is checked by the sum of the digits.
- A number ending in zero or five is divisible by five, and a number ending in zero is divisible by ten.
- The number of factors of a number is found by adding one to each exponent in its prime factorisation and multiplying.
- The unit digit of a power repeats in a short cycle decided by the unit digit of the base.
- Prime has exactly two factors; 1 is neither prime nor composite; 2 is the only even prime.
- Divisibility: 3 by digit sum, 4 by last two digits, 8 by last three digits, 11 by alternating digit sum.
- HCF × LCM = product of the two numbers.
- Unit digit of a power follows a cycle.
Frequently Asked Questions
What is the difference between place value and face value?
The face value of a digit is the digit itself; the place value is the digit multiplied by the value of its position. In 3,74,251 the face value of seven is seven but its place value is seventy thousand.
Why is one neither prime nor composite?
A prime number has exactly two factors and a composite number has more than two; one has only one factor, so it belongs to neither group.
How do you find the number of factors of a number quickly?
Write the number as a product of powers of primes, add one to every exponent and multiply the results. For 48 = 2 to the power 4 times 3, the count is 5 times 2 = 10.
What is the relation between the HCF, the LCM and the two numbers?
The product of the two numbers equals the product of their HCF and their LCM.
Which is the only even prime number?
Two is the only even prime number.